#SRI-8690-0010

SRI GC DETECTORS - FID - FLAME IONIZATION DETECTOR and METHANIZER ACCESSORY

  • Hydrocarbon selective
  • Robust, linear, and stable
  • Detects down to 1ppm levels
  • Ceramic igniter runs hot to keep flame lit.

The FID detector is the most commonly used GC detector, responding linearly from its minimum detectable quantity of about 100 picograms to almost 100%. The FID response is very stable from day to day, and is not susceptible to contamination from dirty samples or column bleed. The FID detector responds to any molecule with a carbon-hydrogen bond, but not at all or poorly to compounds such as H2S, CCl4, or NH3. The carrier gas effluent from the GC column is mixed with hydrogen and then routed through an unbreakable stainless steel jet.

The hydrogen supports a flame at the tip of the jet, ionizing the analyte molecules. A collector electrode attracts the negative ions to the electrometer amplifier producing an analog signal which is connected to the data system input.

Unlike many other FID designs, the SRI FID detector employs a unique ceramic igniter which can run hot continuously, thus totally preventing the flame from extinguishing even when presented with large water injections or pressure surges from column backflush. The FID is thermostatted in an aluminum block up to 375°C and is equipped with a electrometer amplifier which has high, medium, and low gain settings. Hydrogen and air gas flows are controlled using Electronic Pressure Control ( EPC ) for high precision. The optional built-in "whisper quiet" air compressor ( part# SRI-8690-0070 ) is often used to supply the air for the FID, eliminating the bulky air cylinder.

Click Here for printable FID technical overview (.pdf).

HOT TIP:

Up to six detectors can be mounted on the 8610C GC Mainframe.

$2,059.00
 

SRI GC DETECTOR OPTIONS

Fourteen detector combinations are available for mounting on the SRI Models 8610C and 310 GC mainframes.You can also upgrade your current GC or add more analytical power to your lab with these detectors as Stand-Alone units on the Model 110 detector chassis.

Up to six detectors may be mounted along the right hand side of the 8610C GC's column oven and used simultaneously (although some rare combinations of detectors may conflict because of space limitations). Each detector is equipped with a thermostatted heater block for temperature stability, electronic pressure controlled (EPC) support gases, such as hydrogen and air for the FID, and internal amplifier electronics. Select your detector type(s) based on your particular measurement application, detection limit required, matrix interferences, and/or regulatory guidelines.

All detectors require factory installation.

More Information
Selections Detector Options
Details FID DETECTOR
Selections Detector Options
Quadrex © 2021. All Rights Reserved

Secure Payments Method payment methods